Hi,
I just took delivery of my DT HTI in its hard case. Except, the hard case does not come with form fitting foam. I got the inside measurements from the company and ordered special 2 inch thick foams from ‘Case Club.’ I had no idea foams could be that expensive (I paid close to $300) for enough foam for the case and an additional sheet for just in case if I mess up. This would be my first “sculpture” practice cutting foam to fit and was wondering if any of you had done this before and had tips on what to do and what not to do. Thanks.
I have a video on how to do it here https://youtu.be/nZ78XgaKeC4?si=ns_aOIwKiyhAiqi7
The video was Just under 8 minutes. I don’t have an electric knife either, but I do have Shun razor sharp kitchen knives and I was going to use their shortest knife which is about the same size as your pocket knife you used in your video. Thanks a lot.
I did mine this way… its just ok. Sloppy
But whatever, it just protects the gun. Itll do
1 Like
I am going to work on it this weekend. Will let you know how it goes.