Sig Cross Sight In

1

So I bought the Sig Cross 6.5CM used, looked new, and put a Burris Veracity 4-20x50 on it. I love that scope maybe that is why I have 4 of them. I went to the gun range for a quickie sight in. I had asked Jim about reloads since he has a good load for his Sig Cross. I had a box of Hornady 143gr ELDX that I used to sight it in with. I did some reloading last weekend for my 6.5prc, using the same 143gr ELDX. Seems like a good plan using the same bullet for both.
I was really please with the factory group, and I think if I slowed down I could tighten it up. So here is 5 rounds at 100 yards.

Sig Cross Sight In 6.5cm
Sig Cross Sight In 6.5cm1920×2560 339 KB

My Sig Cross. I actually think I need to go with a higher ring, I find it difficult to get down even with the cheek weld at the lowest setting.

Sig Cross 6.5CM
Sig Cross 6.5CM1920×1440 405 KB

3 Likes
2

That is a mighty fine setup, I must say. Good results with the factory ammo too.

3

What size rings would work best? For the sig cross?

4

That will depend on what scope you are putting on the rifle.

5

NX8 night force. Let me know what you recommend.

6

Or the vortex razor 4.5-22

7

Yeah I was having a rough time with a few different bullet options and then switched to loading the 143 ELD-X (holding everything else constant) and it was night and day.

From some other posts seems like the ELD-X is consistently the favorite of the cross from an accuracy standpoint.